No products in the cart.
Getting ready
It is advised to wear suitable protective personal equipment (PPE) and be in safe working environment. Before starting this maintenance process, below tasks must be completed:
- Disconnect battery / power supply
- Housing Removal
- Gearbox Cover Removal
Tools required
| 2mm Allen Key |  |
Parts required
You will need to prepare the listed parts for this maintenance procedure.
| Replacement Ambient Light Sensor Module x 1 unit |  |
Steps to follow
Step 1 Removing old Ambient Light Sensor Module
| Using 2mm Allen Key, unscrew all M2 screws from the Ambient Light Sensor module. |  |
| Disconnect the Ambient Light Sensor module from the PCA board module. |  |
Step 2 Installing new Ambient Light Sensor Module
| Collect the new Ambient Light Sensor Module and align it to its correct screw holes. |  |
| Using an 2mm Allen Key, insert 2 units of M2 screws and firmly tighten all screws. |  |
| Connect the module cable with the connector on the PCA board. Make sure that the connected connector is firmly connected & not loose. |  |