Installing Housing

Tools required

Torque Driver
Loctite 2701
or any equivalent thread-locker fluid


Steps to follow

Step 1 Installing new Right Housing

1.1

Collect 1 unit of new Right Housing and install it onto the bike by aligning to the BB Shaft’s hole & Seat Frame.
Make sure that the installed Right Housing is correctly installed & perfectly aligned.
1.2

On the bottom side of the Right Housing, ensure that the cable is perfectly routed & slotted into its correct cable slot.
1.3

On the other side of the Right Housing, insert & firmly tighten 1 unit of Socket Head Cap screw to the Gearbox Module.
1.4

Using a torque driver, insert and firmly tighten the Socket Head Cap screws on the front side of the Right Housing.
1.5

Continue to remove the rest of the Socket Head Cap screws.

Total 3 units of Socket Head Cap screws must be removed from the the front side of the Right Housing. 

Step 2 Installing new Left Housing

2.1

Collect 1 unit of Left Housing and install it onto the bike by aligning to the BB Shaft’s hole and Seat Frame.
Make sure that the installed Left Housing is correctly installed & perfectly aligned.
2.2

On the front side of the housing, check the alignment with Front Logo and ensure that the Right Housing is fully flushed with the Front Logo.

Make sure that all cables are perfectly aligned into the cable holes and not stuck in between the housing before securing Left & Right housing.
2.3

On the other side of the Right Housing, insert & firmly tighten 1 unit of Socket Head Cap screw to the Gearbox Module.
2.4

On the bottom side of the Left Housing, ensure that the cable is perfectly routed and slotted into its correct cable slot.
2.5

Using a torque driver, insert and firmly tighten 3 units of Socket Head Cap screws on the front side of the Left Housing.

Apply Loctite on each screw before inserting into screw hole. 

Step 3 Installing new Right Rear Housing

3.1

Collect 1 unit of new Right Rear Housing subassembly.

Start installing the Right Rear Housing by sliding it in between the brake caliper.
3.2

Make sure that the Right Rear Housing is fully flushed with Gearbox Module & perfectly aligned with the Left Housing.
3.3

Using a torque driver, insert and firmly tighten 4 units of Socket Head Cap screws into its respective screw holes.

Apply Loctite on each screw before inserting into screw hole. 

End of Article

Table of Contents