No products in the cart.
Stand Cam Replacement
Getting ready
It is advised to wear suitable protective personal equipment (PPE) and be in safe working environment. Before starting this maintenance process, below tasks must be completed:
- Disconnect the battery / power supply
Tools required
| Allen Key |  |
| Circlip Plier |  |
Parts required
You will need to prepare the listed parts for this maintenance procedure.
| Replacement Stand Cam x 1 unit |  |
Steps to follow
Step 1 Crank Removal
For this step, kindly refer the crank removal procedure by clicking the link below.
Step 2 Kickstand Removal
For this step, kindly refer the kickstand removal procedure by clicking the link below.
Step 3 Housing Removal
For this step, kindly refer the housing removal procedure by clicking the link below.
Step 4 Removing old Stand Cam
| 4.1 Retract the Stand Cam by rotating it clockwise until it is fully snapped towards the left side. |  |
| 4.2 Using an 5mm Allen Key, loosen up the Button Head Socket Cap screw from the Stand Cam. Remove the screw from the Stand Cam. |  |
| 4.3 Once the screw has been removed, carefully remove the Stand Cam from the bike. Remove the Stand Cam along with its keyway. |  |
Step 5 Installing new Stand Cam
| 5.1 Collect 1 unit of keyway and align it into its correct key seat. Make sure that its perfectly aligned & hold it in place. |  |
| 5.2 Take the new Stand Cam and carefully aligned it into the Stand Shaft and the keyway. |  |
| 5.3 Make sure that the orientation is correct by referring the teeth’s positioning. |  |
| 5.4 Take the Button Head Cap screws and insert it into its screw hole. Using an Allen Key, firmly tighten the screws until the Stand Cam is fully secured. |  |
Step 7 Re-installing Kickstand
For this step, kindly refer the kickstand installation procedure by clicking the link below.
Step 8 Re-installing Crank
For this step, kindly refer the crank installation procedure by clicking the link below.