No products in the cart.
Handlebar Replacement
Getting ready
It is advised to wear suitable protective personal equipment (PPE) and be in safe working environment. Before starting this maintenance process, below tasks must be completed:
- Disconnect battery / power supply
Tools required
| M5 Allen Key |  |
Parts required
You will need to prepare the listed parts for this maintenance procedure.
| Replacement Handlebar x 1 unit |  |
Steps to follow
Step 1 Removing Hand Grips & Throttle
| 1.1 Using hand, carefully pull out the hand grip from the right-side of the handlebar. |  |
| 1.2 If the bike has a throttle, continue to pull out the throttle from the handlebar. |  |
| 1.3 Repeat the hand grip removal step for the other hand grip on the left-side of the handlebar. |  |
Step 2 Removing Brake Levers
| 2.1 Using an Allen Key, loosen up the screw on both Front & Rear Brake Lever. |  |
| 2.2 Using hand, carefully pull out the brake lever from the right-side of the handlebar. |  |
| 2.3 Repeat the hand grip removal step for the other hand grip on the left-side of the handlebar. |  |
Step 3 Removing Fingerprint Module
| 3.1 Using an Allen Key, loosen up the screws on the back side of the Fingerprint Module. |  |
| 3.2 Using hand, carefully pull out the Fingerprint Module from the handlebar. |  |
Step 4 Removing old Handlebar
| 4.1 Using an Allen Key, loosen up 4 units of Socket Head Cap screws on the Stem Top. Then, remove all screws from the Stem Top. |  |
| 4.2 Once all screws has been removed, lift-off the Stem Top and set it aside. |  |
| 4.3 Remove the old handlebar from the Stem Body |  |
Step 5 Installing new Handlebar
| 5.1 Take the new Handlebar & align it into the Stem Body. Make sure that the handlebar fits perfectly into the Stem Body. |  |
| 5.2 Make sure that the handlebar is centered and the length is well balanced on the right & left side. |  |
| 5.3 Once the alignment of handlebar has been completed, take the Stem Top and carefully align it on top of handlebar. Make sure that all screw holes are aligned. |  |
| 5.4 Using an M5 Allen Key, insert and firmly tighten 4 units of Socket Head Cap screws. |  |
Step 6 Re-installing Fingerprint Module
| 6.1 Using hand, carefully slot in the Fingerprint Module into the left-side of handlebar. |  |
| 6.2 Make sure that the Fingerprint Module are slotted until it reaches the end. Check the orientation and ensure that the orientation is facing towards the correct direction. |  |
| 6.3 Using an Allen Key, insert & tighten up all screws on the back side of Fingerprint Module. | |
Step 7 Re-installing Brake Levers
| 7.1 Take the Rear Brake Lever, and slot it into the right-side of the handlebar. |  |
| 7.2 Make sure that the brake lever is slotted until it reaches the end. Check the orientation and ensure that the orientation is facing towards the correct direction. |  |
| 7.3 Using an Allen Key, tighten up the screw on the Rear brake lever. |  |
| 7.4 Take the Front Brake Lever, and slot it into the right-side of the handlebar. |  |
| 7.5 Make sure that the brake lever is slotted until it reaches the end. Check the orientation and ensure that the orientation is facing towards the correct direction. |  |
| 7.6 Using an Allen Key, tighten up the screw on the Front brake lever. |  |