Getting ready
It is advised to wear suitable protective personal equipment (PPE) and be in safe working environment. Before starting this maintenance process, below tasks must be completed:
- Disconnect battery / power supply
Tools required
Torque Driver | ![]() |
Parts required
You will need to prepare the listed parts for this maintenance procedure.
Replacement Kickstand x 1 unit | ![]() |
Step 1 Removing old kickstand
1.1 Extend the kickstand to its maximum point. | ![]() |
1.2 Using a torque driver, loosen up 1 unit of Flat Head screw. Remove the screw and set it aside. | ![]() |
1.3 Then, retract the kickstand back into its original position. | ![]() |
1.4 Using a torque drive, loosen up 2 units of Socket Head screws. Remove the screws and set it aside. | ![]() |
1.5 Remove the old kickstand from the Stand Cam. | ![]() |
Step 2 Installing new kickstand
2.1 Take the new kickstand & align to its correct screw holes. Ensure that all screw holes are aligned. | ![]() |
2.2 Using a torque driver, insert 1 unit of M4 Flat Head Cap screw and firmly tighten it. | ![]() |
2.3 Retract the kickstand into its close position. | ![]() |
2.4 Using a torque driver, insert 2 units of M3 Socket Head Cap screws and firmly tighten it. | ![]() |